COOLING FAN ECU REMOVAL


  1. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01GMKRE01

      Using both hands, lift the rear side of the cover upwards to detach the 4 clips labeled B. Then slide the cover toward the front of the vehicle to detach the 2 clips labeled A and remove the V-bank cover sub-assembly.

      Note


      • The V-bank cover sub-assembly may be damaged if its front and rear are lifted at the same time.

      • When detaching the clips labeled A, be sure to slide the cover toward the front of the vehicle.

  2. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY


    1. A01GLYAE01

      Remove the 5 clips labeled A.

    2. Lift up the air cleaner inlet cover sub-assembly to detach the 4 clips labeled B, and remove the air cleaner inlet cover sub-assembly.

  3. REMOVE NO. 1 AIR CLEANER INLET


    1. A01GKZB

      Remove the 2 bolts.

    2. A01GJVME01

      Hold the No. 1 air cleaner inlet by the protrusions labeled A and labeled B, and detach the connections.

    3. Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion labeled C.

    4. Hold the No. 1 air cleaner inlet by the protrusions labeled D and labeled E, and detach the connections.

    5. Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion labeled F.

  4. REMOVE COOLING FAN ECU


    1. Disconnect the 3 connectors.

    2. A01GKPW

      Remove the 2 screws and cooling fan ECU.