OIL PRESSURE SWITCH INSTALLATION


  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. A01GJS4E19

      Apply adhesive to 2 or 3 threads of the switch.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    2. Using a 24 mm deep socket wrench, install the switch.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine within 1 hour after installation.

    3. Connect the switch connector.

  2. INSTALL NO. 1 ENGINE UNDER COVER


    1. Install the No. 1 engine under cover with the 13 screws and 7 clips.

  3. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH (for AWD)


    1. for 2WD:

      Install the front wheel opening extension pad LH with the 2 screws.

    2. for AWD:

      Install the front wheel opening extension pad LH with the 5 screws.

  4. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (for AWD)

    Tech Tips

    Use the same procedure described for the LH side.

  5. INSPECT FOR ENGINE OIL LEAK


    1. Start the engine. Make sure that there are no oil leaks from the area that was worked on.