INTAKE AIR CONTROL VALVE ACTUATOR INSTALLATION


  1. INSTALL INTAKE AIR CONTROL VALVE ACTUATOR

    A01GMOA

    1. Temporarily install the actuator rod to the intake air control valve actuator.

    2. Install the intake air control valve actuator to the intake manifold with the 2 bolts.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

    3. Install the actuator rod to the intake air control valve actuator with the nut.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      When tightening the nut, hold the actuator rod in place so that it does not move.

    4. Connect the intake air control valve connector.

  2. INSTALL V-BANK COVER SUB-ASSEMBLY


    1. A01GMKRE01

      Slide the cover from the vehicle front toward the rear of the vehicle to attach the 2 clips labeled A, and then attach the 4 clips labeled B to install the V bank cover sub-assembly.

      Note


      • Make sure the clips are attached securely.

      • Attaching the clips forcefully or hitting the top of the clips may damage them.

      • When attaching the clips labeled A, be sure to slide the cover from the front of the vehicle toward the rear of the vehicle.