REAR CRANKSHAFT OIL SEAL (for 2WD) REPLACEMENT


  1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

    Click here

  2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A01GI1XE01

      Using SST, hold the crankshaft.

      SST
      09213-54015   ( 90119-08216 )
      09330-00021
    2. A01GMQK

      Remove the 10 bolts, rear spacer plate, drive plate and ring gear sub-assembly and crankshaft position sensor rotor.

  3. REMOVE ENGINE REAR OIL SEAL


    1. A01GHJO

      Remove the engine rear oil seal with a screwdriver.

      Tech Tips

      Tape the screwdriver tip before use.

      Note

      Do not damage the surface of the engine rear oil seal press fit hole and crankshaft.

  4. INSTALL ENGINE REAR OIL SEAL


    1. A01GLQGE01

      Using SST, tap in a new engine rear oil seal until its surface is flush with the oil seal retainer edge.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )

      Note


      • Keep the lip free from foreign matter.

      • Do not tap on the engine rear oil seal at an angle.

  5. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A01GN8RE01

      Using SST, hold the crankshaft.

      SST
      09213-54015   ( 90119-08216 )
      09330-00021

    2. Clean the their installation holes.

    3. A01GJBVE06

      Install the crankshaft position sensor rotor.

      Tech Tips


      • Align the pin of the crankshaft with the pin hole of the crankshaft position sensor rotor.

      • As the crankshaft position sensor rotor are not reversible, be sure to install it in the direction shown in the illustration.

    4. A01GMG5E08

      Install the drive plate and ring gear sub-assembly and rear spacer plate on the crankshaft.

      Tech Tips

      As the drive plate and ring gear sub-assembly and rear spacer plate are not reversible, be sure to install it in the direction shown in the illustration.

    5. A01GLAWE01

      Apply a few drops of adhesive to 2 or 3 threads of the bolt end.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    6. A01GMQKE01

      Uniformly install and tighten 10 new bolts in the sequence shown in the illustration.

      Torque:
      30 N*m  { 301 kgf*cm, 22 ft.*lbf }

      Note


      • Do not reuse the drive plate installation bolts.

      • Do not impact or damage the drive plate installation bolts. Be sure to handle them carefully.

    7. Mark the upside of each drive plate installation bolt with paint.

    8. Retighten the drive plate installation bolts by 90°.

    9. Check that the painted marks are now at a 90° angle to the upside.

  6. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

    Click here