CAMSHAFT (for Bank 2) REMOVAL


  1. REMOVE CHAIN SUB-ASSEMBLY

    Click here

  2. REMOVE CAMSHAFT BEARING CAP (for Bank 2)


    1. A01GKY8E01

      Make sure that the knock pin of the camshaft is positioned as shown in the illustration.

    2. A01GMRQE01

      Uniformly loosen and remove the 8 bearing cap bolts in the sequence shown in the illustration.

    3. A01GLQQE01

      Uniformly loosen and remove the 18 bearing cap bolts in the sequence shown in the illustration.

      Note

      Uniformly loosen the bolts while keeping the camshaft level.

    4. Remove the 7 bearing caps.

      Note

      Arrange the removed parts in the correct order.

    5. Remove the No. 1 and No. 2 camshafts.

  3. REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY (for Bank 2)


    1. A01GIBB

      Remove the camshaft housing by prying between the cylinder head and camshaft housing with a screwdriver.

      Note

      Be careful not to damage the contact surfaces of the cylinder head and camshaft housing.

      Tech Tips

      Tape the screwdriver tip before use.