ENGINE UNIT REPLACEMENT


  1. REPLACE TIMING CHAIN COVER STRAIGHT PIN


    1. A01GLMTE01

      Remove the straight pin.

    2. Using a plastic-faced hammer, tap in new straight pins to the timing chain cover.

      Standard protrusion
      5.5 to 6.5 mm (0.217 to 0.256 in.)

  2. REPLACE TIMING CHAIN COVER RING PIN


    1. A01GN6RE01

      Remove the ring pin.

    2. Using a plastic-faced hammer, tap in new ring pins to the timing chain cover.

      Standard protrusion
      Item Specified Condition
      Ring pin A 7.5 to 8.5 mm (0.295 to 0.335 in.)
      Ring pin B 3.6 to 4.6 mm (0.142 to 0.181 in.)

  3. REPLACE ENGINE REAR OIL SEAL


    1. A01GNGQE01

      Place the oil seal retainer on wooden blocks.

    2. Using a screwdriver and hammer, tap out the oil seal.

    3. A01GMVOE01

      Using SST, tap in a new oil seal until its surface is flush with the oil seal retainer edge.

      SST
      09223-15030
      09950-70010   ( 09951-07100 )

      Note


      • Keep the lip free from foreign matter.

      • Do not tap on the oil seal at an angle.