DRIVE BELT INSTALLATION


  1. INSTALL V-RIBBED BELT


    1. A01GMNLE01

      Install the V-ribbed belt as shown in the illustration.

      Note

      Check that the V-ribbed belt is properly set to each pulley.


      1. Rotate the tensioner pulley counterclockwise, and then remove the fix bar.

  2. INSTALL INTAKE AIR CONNECTOR PIPE


    1. Install the intake air sound creator.

      Tech Tips

      Only perform this procedure when replacement of the intake air sound creator is necessary.


      1. Install the intake air sound creator with the bolt and hose clamp.

        Torque:
        2.0 N*m  { 20 kgf*cm, 18 in.*lbf }

    2. Align the protrusion of the intake air resonator with the cutout of the bracket and insert the protrusion.

    3. Install the intake air connector pipe with the 3 hose clamps.

      Torque:
      for intake air connector pipe and throttle body
      4.8 N*m  { 49 kgf*cm, 42 in.*lbf }
      for intake air connector pipe and air cleaner cap
      3.8 N*m  { 39 kgf*cm, 34 in.*lbf }

      Tech Tips


      • Insert the protrusion of the intake air connector pipe into the hole of the hose clamp.

      • The intake air connector pipe and throttle body clamp can be tightened within the range of 4.0 N*m (41 kgf*cm, 35 in.*lbf) to 5.5 N*m (56 kgf*cm, 49 in.*lbf), and the intake air connector pipe and air cleaner cap clamp can be tightened within the range of 2.0 N*m (20 kgf*cm, 18 in.*lbf) to 5.5 N*m (56 kgf*cm, 49 in.*lbf).

    4. Attach the 2 wire harness clamps.

    5. A01GMMEE03

      Connect the No. 1 and No. 2 ventilation hoses to the intake air connector pipe.

      Tech Tips


      • Position the claws of the clamps as shown in the illustration.

      • Install the clamps so that they are within the hose's paint marks.

  3. INSTALL NO. 1 AIR CLEANER INLET


    1. A01GIR0E02

      Align the holes with the connection areas labeled A, and attach the No. 1 air cleaner inlet.

    2. Install the No. 1 air cleaner inlet with the 2 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  4. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY


    1. A01GLYAE01

      Attach the 4 clips labeled B.

      Note


      • Make sure the clips are attached securely.

      • Attaching the clips forcefully or hitting the top of the clips may damage them.

    2. Install the air cleaner inlet cover sub-assembly with the 5 clips labeled A.

  5. INSTALL V-BANK COVER SUB-ASSEMBLY


    1. A01GMKRE01

      Slide the cover from the vehicle front toward the rear of the vehicle to attach the 2 clips labeled A, and then attach the 4 clips labeled B to install the V bank cover sub-assembly.

      Note


      • Make sure the clips are attached securely.

      • Attaching the clips forcefully or hitting the top of the clips may damage them.

      • When attaching the clips labeled A, be sure to slide the cover from the front of the vehicle toward the rear of the vehicle.