CRANKSHAFT POSITION SENSOR ON-VEHICLE INSPECTION


  1. CHECK CRANKSHAFT POSITION SENSOR OUTPUT VOLTAGE

    A01GJ8HE62

    1. Turn the engine switch on (IG).

    2. Measure the voltage according to the value(s) in the table below.

      Standard voltage
      Tester Connection Condition Specified Condition
      E1-18 (VC) - E1-34 (NE-) Engine switch on (IG) 5 V

    3. While turning the crankshaft pulley by hand, measure the voltage between each terminal. Check that the voltage changes between the Hi range and Lo range shown in the table below.

      Standard voltage
      Tester Connection Condition Specified Condition
      E1-27 (NE+) - E1-34 (NE-) Engine switch on (IG)

      3.75 to 4.50 V (Voltage (Hi))

      0.50 to 1.25 V (Voltage (Lo))