CAMSHAFT POSITION SENSOR REMOVAL


  1. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01GMKRE01

      Using both hands, lift the rear side of the cover upwards to detach the 4 clips labeled B. Then slide the cover toward the front of the vehicle to detach the 2 clips labeled A and remove the V-bank cover sub-assembly.

      Note


      • The V-bank cover sub-assembly may be damaged if its front and rear are lifted at the same time.

      • When detaching the clips labeled A, be sure to slide the cover toward the front of the vehicle.

  2. REMOVE CAMSHAFT POSITION SENSOR


    1. A01GIMR

      Disconnect the camshaft position sensor connector.

    2. Remove the bolt and camshaft position sensor.