HEATED OXYGEN SENSOR (for Sensor 2) INSTALLATION


  1. INSTALL HEATED OXYGEN SENSOR (for Bank 1)


    1. A01GKDPE01

      Exterior Side:


      1. Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

        SST
        09224-00010
        Torque:
        without SST
        44 N*m  { 449 kgf*cm, 32 ft.*lbf }
        with SST
        40 N*m  { 408 kgf*cm, 30 ft.*lbf }

        Tech Tips


        • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification Click here.

        • Make sure SST and the wrench are connected in a straight line.

      2. Install the grommet to the vehicle.

    2. A01GLCP

      Interior Side:

      Connect the heated oxygen sensor connector.

  2. INSTALL HEATED OXYGEN SENSOR (for Bank 2)

    A01GLLLE01

    1. Exterior Side:


      1. Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

        SST
        09224-00010
        Torque:
        without SST
        44 N*m  { 449 kgf*cm, 32 ft.*lbf }
        with SST
        40 N*m  { 408 kgf*cm, 30 ft.*lbf }

        Tech Tips


        • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification Click here.

        • Make sure SST and the wrench are connected in a straight line.

      2. Install the grommet to the vehicle.

    2. A01GLJ5

      Interior Side:

      Connect the heated oxygen sensor connector.

  3. INSTALL REAR NO. 2 AIR DUCT

  4. INSTALL REAR NO. 1 AIR DUCT

  5. INSTALL FRONT FLOOR SILENCER PAD LH

  6. INSTALL FRONT FLOOR SILENCER PAD RH

  7. INSTALL COWL SIDE TRIM BOARD LH


    1. Attach the 3 claws to install the cowl side trim board LH.

  8. INSTALL COWL SIDE TRIM BOARD RH

    Tech Tips

    Use the same procedure described for the LH side.

  9. INSTALL FRONT DOOR SCUFF PLATE LH

    A01GM5C

    1. Attach the 4 clips.

    2. Attach the 7 claws to install the front door scuff plate LH.

  10. INSTALL FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure described for the LH side.