HEATED OXYGEN SENSOR (for Sensor 1) INSTALLATION


  1. INSTALL HEATED OXYGEN SENSOR (for Bank 1)

    A01GJ6LE01

    1. Using SST, remove the heated oxygen sensor from the exhaust manifold LH.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Tech Tips


      • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification Click here.

      • Make sure SST and the wrench are connected in a straight line.

  2. INSTALL HEATED OXYGEN SENSOR (for Bank 2)

    A01GMK4E02

    1. Using SST, remove the heated oxygen sensor from the exhaust manifold RH.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Tech Tips


      • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification Click here.

      • Make sure SST and the wrench are connected in a straight line.

  3. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY

    Click here