MASS AIR FLOW METER INSTALLATION

Tech Tips

When viewed from the rear of the engine assembly, Bank 1 is on the left side and Bank 2 is on the right side.


  1. INSTALL MASS AIR FLOW METER (for Bank 1)


    1. A01GLWS

      Install the mass air flow meter with the 2 screws.

      Torque:
      1.0 N*m  { 10 kgf*cm, 9 in.*lbf }

      Note


      • If the screw is tightened excessively, the screw hole may be damaged.

      • Make sure the O-ring is not pinched.

  2. REMOVE MASS AIR FLOW METER (for Bank 2)


    1. A01GHWD

      Install the mass air flow meter with the 2 screws.

      Torque:
      1.0 N*m  { 10 kgf*cm, 9 in.*lbf }

      Note


      • If the screw is tightened excessively, the screw hole may be damaged.

      • Make sure the O-ring is not pinched.

  3. INSTALL AIR CLEANER CAP LH


    1. A01GIOH

      Install the air cleaner cap to the air cleaner hose assembly with the hose clamp.

      Torque:
      3.8 N*m  { 38 kgf*cm, 34 in.*lbf }

      Note

      Insert the protrusion of the air cleaner hose into the hole of the hose clamp.

      Tech Tips

      The hose clamp can be tightened within the range of 2.0 N*m (20 kgf*cm. 18 in.*lbf) to 5.5 N*m (56 kgf*cm. 49 in.*lbf).

    2. Install the air cleaner cap to the air cleaner case with the 2 clips.

    3. Connect the mass air flow meter connector.

  4. INSTALL AIR CLEANER CAP RH


    1. A01GIN9

      Install the air cleaner cap to the air cleaner hose assembly with the hose clamp.

      Torque:
      3.8 N*m  { 38 kgf*cm, 34 in.*lbf }

      Note

      Insert the protrusion of the air cleaner hose into the hole of the hose clamp.

      Tech Tips

      The hose clamp can be tightened within the range of 2.0 N*m (20 kgf*cm. 18 in.*lbf) to 5.5 N*m (56 kgf*cm. 49 in.*lbf).

    2. Install the air cleaner cap to the air cleaner case with the 2 clips.

    3. Connect the mass air flow meter connector.

  5. INSTALL V-BANK COVER SUB-ASSEMBLY

    A01GLQ5E01

    1. After sliding the cover from the vehicle front to the rear to attaching the 2 clips labeled A, attach the 4 clips labeled B and install the V-bank cover sub-assembly.

      Note


      • Make sure the clips are attached securely.

      • Attaching the clips forcefully or hitting the top of the clips may damage them.