ECM INSTALLATION


  1. INSTALL ECM

    A01GLAY

    1. Install the ECM with the 2 nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. Connect the 6 ECM connectors.

  2. INSTALL TCM

    A01GLBN

    1. Install the TCM with the 2 nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. Connect the 4 TCM connectors.

  3. INSTALL ENGINE ROOM ECU COVER

    A01GIBD

    1. Install the engine room ECU cover with the 3 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

  4. INSTALL ENGINE ROOM SIDE COVER LH


    1. Install the engine room side cover LH with the 5 clips.

  5. INSTALL AIR CLEANER INLET COVER

    A01GNHGE01

    1. Attach the 4 clips B.

      Note


      • Make sure the clips are attached securely.

      • Attaching the clips forcefully or hitting the top of the clips may damage them.

    2. Install the air cleaner inlet cover sub-assembly with the 5 clips labeled A.

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. INSTALL COWL TOP VENTILATOR LOUVER RH


    1. A01GM4S

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.

  8. PERFORM RESET MEMORY

    Note

    Perform the RESET MEMORY (AT initialization) when replacing the automatic transmission assembly, engine assembly or ECM Click here.

    Tech Tips

    Initialization cannot be completed by only removing the battery.