POWER SHOULDER BELT ANCHORAGE SYSTEM DATA LIST / ACTIVE TEST


  1. READ DATA LIST

    Tech Tips

    Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values deciding whether a part is faulty or not.


    1. Warm up the engine.

    2. Turn the engine switch off.

    3. Connect the intelligent tester to the DLC3.

    4. Turn the engine switch on (IG).

    5. Turn the tester on.

    6. Enter the following menus: Body / (desired system) / Data List.

    7. According to the display on tester, read the "Data List".

      Front door ECU LH:
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Seat belt anchor up Shoulder belt anchorage switch / OFF or ON

      ON: UP switch is pressed

      OFF: Switch is not pressed

      		 -
      Seat belt anchor down Shoulder belt anchorage switch / OFF or ON

      ON: DOWN switch is pressed

      OFF: Switch is not pressed

      		 -
      Front door ECU RH:
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Seat belt anchor up Shoulder belt anchorage switch / OFF or ON

      ON: UP switch is pressed

      OFF: Switch is not pressed

      		 -
      Seat belt anchor down Shoulder belt anchorage switch / OFF or ON

      ON: DOWN switch is pressed

      OFF: Switch is not pressed

      		 -
      D-SEAT SW :
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Mirror Memory No.1 Driver side position memorized with M1 switch / MEM or NOT MEM

      MEM: Memorized

      NOT MEM: Not memorized

      		 -
      Mirror Memory No.2 Driver side position memorized with M2 switch / MEM or NOT MEM

      MEM: Memorized

      NOT MEM: Not memorized

      		 -
      Mirror Memory No.3 Driver side position memorized with M3 switch / MEM or NOT MEM

      MEM: Memorized

      NOT MEM: Not memorized

      		 -

  2. PERFORM ACTIVE TEST

    Tech Tips

    Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    Note

    When a BODY NO. 4 (rear junction block ECU) related vehicle switch is ON, Active Test items related to the vehicle switch are prohibited (double operation prohibition). Check that the vehicle switches are OFF before performing Active Tests.


    1. Warm up the engine.

    2. Turn the engine switch off.

    3. Connect the intelligent tester to the DLC3.

    4. Turn the engine switch ON.

    5. Turn the tester on.

    6. Enter the following menus: Body / Body No. 4 / Active Test.

    7. According to the display on tester, perform the "Active Test".

      Rear junction block ECU:
      Tester Display Test Part Control Range
      Driver side seat belt anchor motor Seat belt anchor DOWN or UP
      Passenger side seat belt anchor motor Seat belt anchor DOWN or UP