SIDE AIRBAG SENSOR INSTALLATION


  1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY LH


    1. A01GJJ6

      Check that the engine switch is off.

    2. Check that the cable is disconnected from the battery negative (-) terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

    3. Install the side airbag sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that there is no looseness in the installation parts of the side airbag sensor.

    5. Connect the connector.

  2. INSTALL FRONT SEAT BELT RETRACTOR COVER LH


    1. A01GIJL

      Engage the claw and install the front seat belt retractor cover to the body.

  3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSTALL COWL TOP VENTILATOR LOUVER RH


    1. A01GM4S

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      Be sure to install the cowl top ventilator louver RH properly. If it is not installed properly, water may enter the engine room and cause malfunctions.

  6. CHECK SRS WARNING LIGHT

    Click here