FRONT PASSENGER AIRBAG ASSEMBLY INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY


    1. A01GM9NE01
      Text in Illustration
      *1 Hook (A)
      *2 Hook (B)

      Attach the 5 hooks (A).

    2. Push the front passenger airbag assembly to attach the 5 hooks (B).

    3. Install the 2 screws.

  2. INSTALL NO. 2 INSTRUMENT PANEL WIRE


    1. A01GMHX

      Connect the 2 airbag connectors.

      Note


      • When connecting airbag connector, take care not to damage the airbag wire harness.

      • Be sure to only connect the connectors to each corresponding color.

    2. Push in the lock to connect the airbag connector.

    3. Attach the clamp to install the No. 2 instrument panel wire to the front passenger airbag assembly.

  3. INSTALL NO. 3 HEATER TO REGISTER DUCT


    1. Install the No. 3 heater to register duct with the 3 screws.

  4. INSTALL DEFROSTER NOZZLE ASSEMBLY


    1. Install the defroster nozzle assembly with the 3 screws.

  5. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT


    1. Attach the claw to install the No. 2 side defroster nozzle duct.

    2. Install the screw.

  6. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. CHECK SRS WARNING LIGHT

    Click here

  9. INSTALL COWL TOP VENTILATOR LOUVER RH


    1. A01GM4S

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      Be sure to install the cowl top ventilator louver RH properly. If it is not installed properly, water may enter the engine room and cause malfunctions.