FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Push in the lock to connect the airbag connector.

    4. A01GLBI

      Connect the airbag connector to the front passenger side knee airbag assembly.

      Note

      When connecting airbag connector, take care not to damage the airbag wire harness.

    5. Attach the claw to install the front passenger side knee airbag assembly.

    6. Install the 3 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Confirm that the front passenger side knee airbag assembly is installed securely without any excessive gaps and is not protruding outward.

  2. INSTALL LOWER INSTRUMENT PANEL


    1. Attach the 2 claws and clip to install the lower instrument panel.

  3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Connect the connector.

    2. A01GLCW

      Insert the 2 guides.

    3. Attach the 4 claws to install the No. 2 instrument panel under cover sub-assembly.

  4. INSTALL INSTRUMENT SIDE PANEL RH

    A01GNEH

    1. Attach the 6 clips to install the instrument side panel RH.

  5. INSTALL INSTRUMENT PANEL FINISH PANEL END RH

    Tech Tips

    Use the same procedure described for the LH side.

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. CHECK SRS WARNING LIGHT

    Click here

  8. INSTALL COWL TOP VENTILATOR LOUVER RH


    1. A01GM4S

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      Be sure to install the cowl top ventilator louver RH properly. If it is not installed properly, water may enter the engine room and cause malfunctions.