СИСТЕМА БЕССТУПЕНЧАТОЙ ТРАНСМИССИИ ПРОЦЕДУРА ПОИСКА НЕИСПРАВНОСТЕЙ

Tech Tips


  • The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, be sure to check that there is no trouble in the CAN communication system.


  • *: Use the intelligent tester.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. CUSTOMER PROBLEM ANALYSIS


    NEXT

  3. INSPECT BATTERY VOLTAGE

    Standard voltage
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT

  4. CONNECT INTELLIGENT TESTER TO DLC3*


    NEXT

  5. CHECK AND CLEAR DTCS AND FREEZE FRAME DATA*

    Tech Tips

    Record or print DTCs and freeze frame data, if necessary.


    1. Refer to DTC Check/Clear Click here.


      NEXT

  6. VISUAL INSPECTION


    NEXT

  7. SETTING CHECK MODE DIAGNOSIS*


    1. Refer to Check Mode Procedure Click here.


      NEXT

  8. PROBLEM SYMPTOM CONFIRMATION


    1. Refer to Road Test Click here.

      Result
      Result Proceed to
      Symptom does not occur A
      Symptom occurs B

      B

      GO TO STEP 10
      A

  9. SYMPTOM SIMULATION


    1. Refer to Electronic Circuit Inspection Click here.


      NEXT

  10. DTC CHECK*


    1. Refer to DTC Check/Clear Click here.

      Result
      Result Proceed to
      DTC not output A
      DTC output B

      B

      GO TO STEP 16
      A

  11. BASIC INSPECTION


    1. Refer to Continuously Variable Transaxle Fluid Click here.

    2. Refer to Park/Neutral Position Switch Click here.

    3. Refer to Shift Lever Click here.


      NG

      GO TO STEP 19
      OK

  12. MECHANICAL SYSTEM TEST*


    1. Refer to Mechanical System Test Click here.


      NG

      GO TO STEP 15
      OK

  13. HYDRAULIC TEST*


    1. Refer to Hydraulic Test Click here.


      NG

      GO TO STEP 15
      OK

  14. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table Click here.


      NG

      GO TO STEP 17
      OK

  15. COMPONENT INSPECTION


    NG

    GO TO STEP 19
    OK

  16. DTC CHART


    1. Refer to Diagnostic Trouble Code Chart Click here.


      NEXT

  17. CIRCUIT INSPECTION


    NEXT

  18. IDENTIFICATION OF PROBLEM


    NEXT

  19. REPAIR OR REPLACE


    NEXT

  20. CONFIRMATION TEST


    NEXT
    END