ТРОС МЕХАНИЗМА ПЕРЕКЛЮЧЕНИЯ ПЕРЕДАЧ РЕГУЛИРОВКА


  1. INSPECT SHIFT LEVER POSITION


    1. When moving the shift lever from P to R with the engine switch on (IG) and the brake pedal depressed, make sure that the shift lever moves smoothly and correctly into position.

    2. Start the engine and make sure that the vehicle moves forward when moving the shift lever from N to D and moves rearward when moving the lever to R.

      If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.

  2. ADJUST SHIFT LEVER POSITION


    1. Apply the parking brake and move the shift lever to N.

    2. Remove the instrument cluster finish panel assembly and center instrument cluster finish panel sub-assembly Click here.

    3. A01CF9Y

      Disconnect the end of the transmission control cable assembly from the shift lever assembly.

    4. A01CDA7E01
      Text in Illustration:
      *1 Stopper

      Pull out the stopper of the transmission control cable.

      Note

      Do not remove the stopper. If the stopper is removed, reinstall it to its original position.

    5. A01CFGWE01
      Text in Illustration
      *1 Nut
      *2 Shift Lever Retainer

      Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable assembly from the shift lever retainer.

      Note

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable assembly will not be reusable.

    6. A01CE5AE04
      Text in Illustration
      *1 Lock Piece
      *a Side View
      *b Bottom View
      *c Side View
      *d Push

      Push the 2 claws together at the top of the transmission control cable assembly lock piece. While holding the 2 claws together, push the 2 lugs on the bottom of the lock piece toward each other and upward to pull out the lock piece.

    7. Turn the nut of the transmission control cable assembly 180° counterclockwise. While holding the nut in place, push in the stopper until the stopper clicks twice.

      A01CF4NE05
      Text in Illustration
      *1 Nut *2 Stopper
      *a Push in - -

    8. Install the outer part of the transmission control cable assembly to the shift lever retainer. Check that the spring is positioned at "A" and push in the stopper.

      A01CD6HE03
      Text in Illustration
      *1 Shift Lever Retainer *2 Stopper
      *3 Spring - -
      *a Push in - -

      Tech Tips

      If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

    9. A01CF26E01
      Text in Illustration
      *1 Lock Piece

      Install the cable end to the shift lever assembly.

      Note


      • Check that the lock piece is pulled up.

      • Install the cable end all the way to the base of the pin.

    10. A01CDVRE05
      Text in Illustration
      *1 Lock Piece
      *2 Adjuster Case
      *a Push in

      Push the lock piece into the adjuster case.

      Note

      Securely press in the lock piece until it locks.

    11. After adjusting the shift lever position, check the operation and function of the shift lever. If there is a problem, adjust the position again.

    12. Install the instrument cluster finish panel assembly and center instrument cluster finish panel sub- assembly Click here.