ДАТЧИК СОСТАВА ТОПЛИВОВОЗДУШНОЙ СМЕСИ УСТАНОВКА


  1. INSTALL AIR FUEL RATIO SENSOR


    1. A01CCPKE01
      Text in Illustration
      *1

      Fulcrum Length

      30 mm

      Using SST, install the air fuel ratio sensor.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      39 N*m  { 398 kgf*cm, 29 ft.*lbf }

      Note


      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 260 mm (10.23 in.) Click here.

      • This torque value is effective when SST is parallel to the torque wrench.

    2. A01CCF3

      Connect the air fuel ratio sensor connector and wire harness clamp.

  2. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    1. Install the No. 1 exhaust manifold heat insulator with the 4 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

  3. INSPECT FOR EXHAUST GAS LEAK