ДАТЧИК ПОЛОЖЕНИЯ КОЛЕНЧАТОГО ВАЛА УСТАНОВКА


  1. INSTALL CRANK POSITION SENSOR (for TMC Made)


    1. A01CEJOE08
      Text in Illustration
      *1 New O-ring

      Apply a light coat of engine oil to the O-ring on the crank position sensor.

    2. A01CBSU

      Install the crank position sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note

      Do not twist the O-ring.

    3. Install the 2 wire harness clamps.

    4. Install the connector to the connector bracket.

    5. A01CCSS

      Connect the crank position sensor connector.

  2. INSTALL CRANK POSITION SENSOR (except TMC Made)


    1. A01CEJOE08
      Text in Illustration
      *1 New O-ring

      Apply a light coat of engine oil to the O-ring on the crank position sensor.

    2. A01CGAR

      Install the crank position sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note

      Do not twist the O-ring.

    3. Install the wire harness clamp.

    4. Install the connector to the connector bracket.

    5. A01CCSS

      Connect the crank position sensor connector.

  3. INSTALL GENERATOR ASSEMBLY


    1. Install the generator assembly Click here.