ДАТЧИК ПОЛОЖЕНИЯ КОЛЕНЧАТОГО ВАЛА СНЯТИЕ


  1. REMOVE GENERATOR ASSEMBLY


    1. Remove the generator assembly Click here.

  2. REMOVE CRANK POSITION SENSOR (for TMC Made)


    1. A01CCSS

      Disconnect the crank position sensor connector.

    2. A01CBSU

      Disconnect the connector from the connector bracket.

    3. Disconnect the 2 wire harness clamps.

    4. Remove the bolt and crank position sensor.

  3. REMOVE CRANK POSITION SENSOR (except TMC Made)


    1. A01CCSS

      Disconnect the crank position sensor connector.

    2. A01CGAR

      Disconnect the connector from the connector bracket.

    3. Disconnect the wire harness clamp.

    4. Remove the bolt and crank position sensor.