СИСТЕМА SFI, Diagnostic DTC:P0604, P0606, P0607, P060A, P060D, P060E, P0657, P1607

DTC Code DTC Name
P0604 Internal Control Module Random Access Memory (RAM) Error
P0606 ECM / PCM Processor
P0607 Control Module Performance
P060A Internal Control Module Monitoring Processor Performance
P060D Internal Control Module Accelerator Pedal Position Performance
P060E Internal Control Module Throttle Position Performance
P0657 Actuator Supply Voltage Circuit / Open
P1607 Cruise Control Input Processor

DESCRIPTION

The ECM continuously monitors its internal memory status, internal circuits, and output signals transmitted to the throttle actuator. This self-check ensures that the ECM is functioning properly. If any malfunction is detected, the ECM will set the appropriate DTC and illuminate the MIL.

The ECM memory status is diagnosed by internal "mirroring" of the main CPU and the sub CPU to detect Random Access Memory (RAM) errors. The 2 CPUs also perform continuous mutual monitoring. The ECM illuminates the MIL and sets a DTC if: 1) outputs from the 2 CPUs are different and deviate from the standards, 2) the signals sent to the throttle actuator deviate from the standards, 3) a malfunction is found in the throttle actuator supply voltage, and 4) any other ECM malfunction is found.

DTC No. DTC Detection Condition Trouble Area

P0604

P0606

P0607

P060A

P060D

P060E

P0657

P1607

 ECM internal error (1 trip detection logic) ECM

INSPECTION PROCEDURE

Tech Tips

Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.

PROCEDURE


  1. READ OUTPUT DTC


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the tester on.

    4. Clear the DTCs Click here.

    5. Turn the engine switch off and turn the tester off.

    6. Disconnect the tester.

    7. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

    8. Connect the cable to the negative (-) battery terminal.

    9. Connect the tester to the DLC3.

    10. Turn the engine switch on (IG) and turn the tester on.

    11. Enter the following menus: Powertrain / Engine and ECT / DTC.

    12. Read the DTCs.

      Result
      Result Proceed to
      DTC P0604, P0606, P0607, P060A, P060D, P060E, P0657 and/or P1607 are output A
      DTC is not output B
      DTC P0604, P0606, P0607, P060A, P060D, P060E, P0657, P1607 and other DTCs are output C

      Tech Tips

      If any DTCs other than P0604, P0606, P0607, P060A, P060D, P060E, P0657 or P1607 are output, troubleshoot those DTCs first.


    B

    CHECK FOR INTERMITTENT PROBLEMS Click here

    C

    GO TO DTC CHART Click here

    A

    REPLACE ECM Click here