|DTC Code||DTC Name|
|P0116||Engine Coolant Temperature Circuit Range / Performance Problem|
Refer to DTC P0115 Click here.
|DTC No.||DTC Detection Condition||Trouble Area|
Engine coolant temperature is between -40°C and 60°C (-40°F and 140°F) when engine is started, and conditions (a) and (b) are met (2 trip detection logic):
If any of DTCs P0115, P0117 or P0118 are set simultaneously with DTC P0116, the engine coolant temperature sensor may have an open or a short circuit. Troubleshoot those DTCs first.
Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116)
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
If any DTCs other than P0116 are output, troubleshoot those DTCs first.
GO TO DTC CHART Click here
Remove the thermostat Click here.
Measure the valve opening temperature of the thermostat.
|80°C to 84°C (176°F to 183°F)|
In addition to the above check, confirm that the valve is completely closed when the temperature is below the standard.
Reinstall the thermostat Click here.
REPLACE THERMOSTAT Click here