REAR DOOR ADJUSTMENT

A0136DPE01

Tech Tips


  • Centering bolts are used to mount the door hinge onto the vehicle body and door. The door cannot be adjusted with the centering bolts on. Substitute standard bolts (with washers) for the centering bolts when marking adjustments.

  • For bolts without torque specifications, check the standard bolt chart.


  1. INSPECT REAR DOOR


    1. Check that the clearance measurements are within the standard ranges.

      A0137A1E01

  2. ADJUST REAR DOOR


    1. Disconnect the cable from the negative battery terminal.

      Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.

    2. A0138K5

      Adjust the door horizontally and vertically by loosening the body side hinge bolts.

    3. Tighten the body side hinge bolts after the adjustment.

      Torque:
      26 N*m  { 265 kgf*cm, 19 ft.*lbf }
    4. A0136V9

      Adjust the door horizontally and vertically by loosening the door side hinge bolts.

    5. Tighten the door side hinge bolts after the adjustment.

      Torque:
      26 N*m  { 265 kgf*cm, 19 ft.*lbf }
    6. A01368I

      Adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.

    7. Tighten the striker mounting screws after the adjustment.

      Torque:
      23 N*m  { 235 kgf*cm, 17 ft.*lbf }

    8. Connect the cable to the negative battery terminal.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }