NAME PLATE INSTALLATION


  1. INSTALL BACK DOOR NAME PLATE NO. 6

    A013624

    1. Using an infrared lamp, heat the double sided tape remaining on the rear bumper cover.

      Heating Temperature
      Item Temperature
      Back Door Name Plate No. 6 40 to 60 °C (104 to 140 °F)

    2. Using a shop rag or piece of cloth, rub off the remaining double sided tape from the rear bumper cover.

      Note

      Installing the name plate with any double sided tape remaining on the rear bumper cover may cause adhesion failure. So completely remove the double sided tape.

    3. Install a new back door name plate after cleaning the attachment surface on the rear bumper cover using white gasoline.

  2. INSTALL BACK DOOR NAME PLATE NO. 2

    A01380C

    1. Using an infrared lamp, heat the double sided tape remaining on the rear bumper cover.

      Heating Temperature
      Item Temperature
      Back Door Name Plate No. 6 40 to 60 °C (104 to 140 °F)

    2. Using a shop rag or piece of cloth, rub off the remaining double sided tape from the rear bumper cover.

      Note

      Installing the name plate with any double sided tape remaining on the rear bumper cover may cause adhesion failure. So completely remove the double sided tape.

    3. Install a new back door name plate after cleaning the attachment surface on the rear bumper cover using white gasoline.

  3. INSTALL BACK DOOR EMBLEM NO. 1


    1. Using an infrared lamp, heat the double sided tape remaining on the back door glass.

      Heating Temperature
      Item Temperature
      Back Door Emblem No. 1 40 to 60 °C (104 to 140 °F)

    2. Using a shop rag or piece of cloth, rub off the remaining double sided tape from the back door glass.

      Note

      Installing the name plate with any double sided tape remaining on the back door glass may cause adhesion failure. So completely remove the double sided tape.

    3. Clean the attachment surface on the back door glass using white gasoline.

    4. Apply Primer G to the attachment surface on the back door glass.

      Note


      • Allow the primer to dry for 3 minutes or more.

      • Throw away any leftover Primer G.

      • Do not apply too much Primer G.

    5. A01367ZE01

      Install a new back door emblem.

      Specification
      Area Measurement
      A 59 to 61 mm (2.323 to 2.402 in.)
      B 64.2 to 66.2 mm (2.528 to 2.606 in.)

      Note

      Do not expose the emblem to water within 24 hours of installation.

  4. INSTALL RADIATOR GRILLE EMBLEM

    A0138JI

    1. Engage the 3 claws and install the radiator grille emblem.

  5. INSTALL FRONT BUMPER COVER

    A01360O

    1. Engage the 13 claws and install the front bumper cover.

    2. A013716E01

      Tighten the 3 bolts and 5 screws.

    3. Install the 3 clips.

    4. Remove the protective tape.