FRONT DOOR WINDOW REGULATOR REMOVAL

Tech Tips


  • Use the same procedure for both the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE DOOR ASSIST GRIP COVER

    A0137O5E01

    1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the door assist grip cover.

  3. REMOVE ASSIST GRIP ASSEMBLY

    A0137X5E01

    1. Remove the 2 screws and disengage the 4 claws.

  4. REMOVE FRONT ARMREST BASE PANEL UPPER

    A013827E01

    1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the front armrest base panel upper.

    2. A013832

      Disconnect the connector and remove the front armrest base panel upper.

  5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    A0136RFE01

    1. Remove the screw.

    2. Disengage the 15 clips and remove the front door trim board sub-assembly.

  6. REMOVE FRONT DOOR FRONT LOWER FRAME COVER UPPER

    A0137OM

    1. Remove the front door front lower frame cover upper by sliding it in the direction indicated by the arrow in the illustration.

  7. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

    A0137G6E02

    1. Remove the 2 screws and disengage the 2 clips.

  8. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY

    A0138TB

    1. Remove the 3 screws and outer rear view mirror assembly LH.

  9. REMOVE FRONT DOOR SERVICE HOLE COVER

    A0138PI

    1. Remove the front door service hole cover.

      Note

      Remove any tape remaining on the door.

  10. REMOVE FRONT DOOR GLASS WEATHERSTRIP ASSEMBLY OUTER

    A0135U7E01

    1. Apply protective tape to the outer circumference of the front door belt moulding, as shown in the illustration.

    2. Using a moulding remover, disengage the 5 claws and remove the front door belt moulding.

  11. REMOVE FRONT DOOR GLASS WEATHERSTRIP ASSEMBLY INNER

  12. REMOVE FRONT DOOR GLASS RUN

    A0138IL

    1. Remove the front door glass run.

  13. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

    A01382R

    1. Connect the power window regulator switch.

    2. Move the door glass until the 2 screws can be seen through the service holes.

    3. Remove the 2 screws and front door glass sub-assembly.

      Note

      Do not allow the front door glass sub-assembly to fall or be damaged when removing the screw.

    4. Disconnect the power window regulator switch.

  14. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY

    A01360T

    1. Disconnect the connector.

    2. Remove the 3 nuts and front door window regulator sub-assembly.

      Note

      Do not drop the front door window regulator sub-assembly when removing the nuts.

      Tech Tips

      Remove the front door window regulator sub-assembly through the service hole.