METER / GAUGE SYSTEM Driver Side Seat Belt Warning Light does not Operate

WIRING DIAGRAM

A013700E05

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT FRONT SEAT INNER BELT ASSEMBLY


    1. A013731E02

      Disconnect the H18 front seat inner belt (driver side) connector.

    2. Measure the resistance.

      Standard Resistance
      Terminal No. Condition Specified Condition
      1 - 2 Seat belt fastened 10 kΩ or higher
      1 - 2 Seat belt unfastened Below 1 Ω

    3. Reconnect the front seat inner belt (driver side) connector.


    NG

    REPLACE FRONT SEAT INNER BELT ASSEMBLY

    OK

  2. CHECK HARNESS AND CONNECTOR (FRONT SEAT INNER BELT ASSEMBLY - COMBINATION METER ASSEMBLY)


    1. A01392JE01

      Disconnect the C1 combination meter connector.

    2. Disconnect the H18 front seat inner belt (driver side) connector.

    3. Measure the resistance.

      Standard Resistance
      Tester Connection Specified Condition
      C1-21 - H18-2 Below 1 Ω
      C1-21 or H18-2 - Body ground 10 kΩ or higher

    4. Reconnect the front seat inner belt (driver side) connector.

    5. Reconnect the combination meter connector.


    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE COMBINATION METER ASSEMBLY