DOOR CONTROL TRANSMITTER REGISTRATION


  1. RESISTER RECOGNITION CODES

    Tech Tips


    • Recognition code registration is necessary when the door control transmitter or the door control receiver is replaced with a new one.

    • Add mode is used to register new recognition codes while retaining the previously registered codes. This mode is used when new transmitters are added. If the number of registered codes exceeds 4, the previously registered codes will be erased in order, starting from the first registered code.

    • Rewrite mode is used to erase all the previously registered recognition codes in order to register new recognition codes. This mode is used when the transmitter or the door control receiver is replaced with a new one.

    • Confirmation mode is used to confirm how many recognition codes have already been registered before any additional recognition codes are registered.

    • Prohibition mode is used to erase all the registered codes and disables the wireless door lock function. This mode is used when the transmitters are lost. After using prohibition mode, use confirmation mode to check that the number of registered recognition code is 0.

    • The registration procedure described on the following pages must be performed in order.


    1. The vehicle should be in the following condition.


      1. Turn the ignition switch to OFF.

      2. Open the driver door.

    2. Perform the operations to select the desired mode.


      1. Turn the ignition switch OFF to ON and then ON to OFF.

      2. Close and open the driver door twice, and then turn the ignition switch from OFF to ON to OFF within 40 seconds.

      3. Close and open the driver door twice, then close the driver door and lock all doors using the manual knobs within 40 seconds. Do not use the power locks or the key.

      4. Turn the ignition switch from LOCK to ON and back to LOCK at approximately 1.5 second intervals, 1 to 5 times within 40 seconds, to select a mode (see the table below).

      5. Unlock all doors.

        A0136MOE04

        Note

        If the number of the ON-LOCK operations of the ignition switch is 0, 4, 6 or more, there will be no response to indicate which mode has been selected.

    3. After a mode is selected, the door control with receiver ECU automatically performs the power door lock LOCK-UNLOCK operation to indicate which mode has been selected (see the table below).

      A01385HE01

      Tech Tips


      • In confirmation mode, LOCK-UNLOCK operation will occur once for each recognition code that has been registered. For example, if 2 recognition codes have been registered, LOCK-UNLOCK operation will occur twice.

      • In confirmation mode, if no recognition codes have been registered, LOCK-UNLOCK operation will occur 5 times.

    4. Register a new recognition code (Add mode or Rewrite mode) in accordance with the following procedure.


      1. Remove the key. Within 40 seconds of add mode or rewrite mode being selected, press the LOCK and UNLOCK switches on the transmitter switch of the key simultaneously for 1.0 to 1.5 seconds. Within 3 seconds of moving your finger away from the switches, press either switch of the key for more than 1.0 second.

      2. Within 3 seconds of the transmitter switch being released, the LOCK-UNLOCK operation will be automatically performed once if the registration of the recognition code of the transmitter is correctly completed. If the LOCK-UNLOCK operation is performed twice, the registration of the recognition code has failed, so perform the registration procedure from the beginning once again.

        A0138FME01

    5. If multiple transmitters need to be registered, repeat the registration of a new recognition code procedure within 40 seconds of the previous registration.

    6. If any of the following conditions is met, the registration mode will end.


      1. Ignition switch turned to ON.

      2. Any doors opened.

      3. 40 seconds or more elapses after code registration.

      4. 4 recognition codes registered at once.