HEADLIGHT DIMMER SWITCH INSPECTION


  1. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY


    1. A0138LLE05
      Text in Illustration
      *a

      Component without harness connected

      (Headlight Dimmer Switch Assembly)

      Check the resistance of the light control switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        10 - 13 OFF 10 kΩ or higher
        11 - 12 OFF 10 kΩ or higher
        10 - 13 TAIL Below 1 Ω
        10 - 13 HEAD Below 1 Ω
        11 - 12 HEAD Below 1 Ω

        If the result is not as specified, replace the headlight dimmer switch assembly.

    2. Check the resistance of the headlight dimmer switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        9 - 11 FLASH Below 1 Ω
        8 - 11 LOW BEAM Below 1 Ω
        9 - 11 HIGH BEAM Below 1 Ω

        If the result is not as specified, replace the headlight dimmer switch assembly.

    3. Check the resistance of the turn signal switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        6 - 7 Right turn Below 1 Ω
        6 - 7 Neutral 10 kΩ or higher
        5 - 7 Neutral 10 kΩ or higher
        5 - 7 Left turn Below 1 Ω

        If the result is not as specified, replace the headlight dimmer switch assembly.

    4. Check the resistance of the front fog light switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        2 - 4 OFF 10 kΩ or higher
        2 - 4 Front fog light switch ON Below 1 Ω

        If the result is not as specified, replace the headlight dimmer switch assembly.

    5. Check the resistance of the rear fog light switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        3 - 4 OFF 10 kΩ or higher
        3 - 4 Rear fog light switch ON Below 1 Ω

        If the result is not as specified, replace the headlight dimmer switch assembly.