HEADLIGHT DIMMER SWITCH INSPECTION


  1. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY

    A0138LLE01

    1. Check the resistance of the light control switch.


      1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        - OFF 10 kΩ or higher
        10 - 13 TAIL Below 1 Ω
        10 - 13 HEAD Below 1 Ω
        11 - 12 HEAD Below 1 Ω

        If the result is not as specified, replace the headlight dimmer switch assembly.

    2. Check the resistance of the headlight dimmer switch.


      1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        9 - 11 FLASH Below 1 Ω
        8 - 11 LOW BEAM Below 1 Ω
        9 - 11 HI BEAM Below 1 Ω

        If the result is not as specified, replace the headlight dimmer switch assembly.

    3. Check the resistance of the turn signal switch.


      1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        6 - 7 Right turn Below 1 Ω
        - Neutral 10 kΩ or higher
        5 - 7 Left turn Below 1 Ω

        If the result is not as specified, replace the headlight dimmer switch assembly.

    4. Check the resistance of the rear fog light switch.


      1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        2 - 4 OFF 10 kΩ or higher
        2 - 4 Rear fog light switch ON Below 1 Ω

        If the result is not as specified, replace the headlight dimmer switch assembly.