HEADLIGHT DIMMER SWITCH REMOVAL


  1. PRECAUTION

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.

  3. POSITION FRONT WHEELS FACING STRAIGHT AHEAD

  4. REMOVE STEERING COLUMN COVER UPPER

    A0136OJE02

    1. Remove the 2 screws while turning the steering wheel to the right and left.

    2. Disengage the 4 claws and remove the steering column cover upper.

    3. A0136TV

      Remove the steering column cover upper, as shown in the illustration (w/ tachometer).

    4. A0136HY

      If the steering column cover upper is difficult to remove, loosen the screw behind the tachometer, pull up and extend the tachometer, and then remove the steering cover upper (w/ tachometer).

  5. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

    A0136JFE01

    1. Disconnect the 2 connectors.

    2. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the windshield wiper switch assembly.

      Note

      Do not press the claw too hard, as it may be damaged.

  6. REMOVE STEERING PAD

    A0135YBE01

    1. Place the front wheels facing straight ahead.

    2. Using "Torx" socket wrench T30, loosen the 2 screws until the screw thread catches on the screw case.

    3. A01389P

      Pull the steering pad out of the steering wheel and support the steering pad with one hand, as shown in the illustration.

      Note

      When removing the steering pad, do not pull the airbag wire harness.

    4. Disconnect the horn connector.

    5. Disconnect the airbag connector, as shown in the illustration.

      Note

      When handling the airbag connector, do not damage the airbag wire harness.

    6. Remove the steering pad.

  7. REMOVE STEERING WHEEL ASSEMBLY

    A0138CJ

    1. Remove the nut and put matchmarks on the steering wheel assembly and steering main shaft.

    2. Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

  8. REMOVE SPIRAL CABLE SUB-ASSEMBLY

    A0137TJ

    1. Disconnect the horn connector.

    2. Disconnect the airbag connector, as shown in the illustration.

      Note

      When handling the airbag connector, do not damage the airbag wire harness.

    3. Disconnect the steering angle sensor connector (w/ VSC).

    4. Disengage the 3 claws and remove the spiral cable.

  9. REMOVE COMBINATION METER ASSEMBLY

    A0137AB

    1. Remove the 2 bolts.

    2. Disconnect the 14 connectors and remove the combination meter.

  10. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY

    A0138OWE01

    1. Disconnect the connector.

    2. Remove the headlight dimmer switch assembly, as shown in the illustration.

    3. A0137JG

      Disengage the 2 claws and remove the headlight dimmer switch assembly.