FRONT SEAT SIDE AIRBAG ASSEMBLY INSTALLATION

CAUTION:

Some of these service operations affect the SRS airbag system. Be sure to read the precautionary notices concerning the SRS airbag system before servicing Click here.

Tech Tips


  • Use the same procedure for both the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE SEAT AIRBAG HOOK

    A0138VK

    1. Install the seat airbag hook.

  2. INSTALL FRONT SEAT SIDE AIRBAG ASSEMBLY

    A0138SA

    1. Install the front seat side airbag with the 2 nuts.

      Torque:
      6.1 N*m  { 62 kgf*cm, 54 in.*lbf }
    2. A0136HN

      Install the 3 wire harness clamps.

    3. A0138DV

      Fasten the 2 zippers.

  3. INSTALL FRONT SEAT ASSEMBLY

    A01384RE01

    1. Place the front seat in the cabin.

    2. Using several steps, install and tighten the 4 bolts uniformly in the sequence shown in the illustration.

      Torque:
      22 N*m  { 225 kgf*cm, 16 ft.*lbf }
    3. A013693

      Connect the airbag connector, as shown in the illustration (w/ front seat side airbag).

    4. Connect the buckle switch connector (driver seat only).

    5. Install the wire harness clamp.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  5. INSPECT SRS WARNING LIGHT

    Click here