BLOWER MOTOR INSTALLATION


  1. INSTALL BLOWER FAN MOTOR

    A0136R4

    1. Turn the blower fan motor clockwise, engage the claw and install the blower fan motor.

    2. Connect the connector.

  2. INSTALL INSTRUMENT PANEL REINFORCEMENT


    1. Install the instrument panel reinforcement with the 6 bolts.

      Torque:
      29 N*m  { 300 kgf*cm, 21 ft.*lbf }

    2. Install the screw.

      Note

      Replace the screw with 90168-W0001 screws to avoid insecure installation.

    3. Engage the 7 clamps.

  3. INSTALL RELAY BLOCK ASSEMBLY


    1. Engage the clamp.

    2. Install the relay block assembly with the screw.

      Torque:
      3.7 N*m  { 38 kgf*cm, 32 in.*lbf }

      Note

      Replace the screw with 90168-W0001 screws to avoid insecure installation.

  4. INSTALL CONNECTOR HOLDER


    1. Install the connector holder with the screw.

      Torque:
      3.7 N*m  { 38 kgf*cm, 32 in.*lbf }

  5. INSTALL DOOR CONTROL WITH RECEIVER ECU ASSEMBLY


    1. Install the door control with receiver ECU assembly with the bolt.

      Torque:
      3.7 N*m  { 38 kgf*cm, 32 in.*lbf }

    2. Connect the connector.

  6. INSTALL TRANSPONDER KEY ECU ASSEMBLY


    1. Connect the connector.

    2. Install the transponder key ECU assembly with the bolt.

      Torque:
      3.7 N*m  { 38 kgf*cm, 32 in.*lbf }

  7. INSTALL INSTRUMENT PANEL BRACE SUB-ASSEMBLY NO. 1


    1. Install the instrument panel brace sub-assembly No. 1 with the bolt, nut and screw.

      Torque:
      29 N*m  { 300 kgf*cm, 21 ft.*lbf, for bolt }
      29 N*m  { 300 kgf*cm, 21 ft.*lbf, for nut }
      1.2 N*m  { 12 kgf*cm, 11 in.*lbf, for screw }

    2. Install the 2 wire harness clamp bolts.

    3. Engage the 2 clamps.

    4. Install the floor carpet with the clip.

  8. INSTALL STEERING COLUMN ASSEMBLY

    Click here