PARKING BRAKE LEVER INSTALLATION


  1. INSTALL PARKING BRAKE SWITCH ASSEMBLY

    A01366R

    1. Install the parking brake switch with the screw.

  2. INSTALL PARKING BRAKE LEVER SUB-ASSEMBLY

    A01376A

    1. Install the parking brake lever with the 2 bolts.

      Torque:
      14.5 N*m  { 148 kgf*cm, 11 ft.*lbf }
    2. A0138C1

      Connect the parking brake switch connector.

  3. INSTALL PARKING BRAKE EQUALIZER

    A0137WU

    1. Install the equalizer with a new adjusting nut.

  4. INSPECT PARKING BRAKE LEVER TRAVEL


    1. Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.

      Parking brake lever travel
      5 to 8 clicks at 196 N (20 kgf, 44 lbf)

  5. ADJUST PARKING BRAKE LEVER TRAVEL

    A0137NM

    1. Turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.

      Parking brake lever travel
      5 to 8 clicks at 196 N (20 kgf, 44 lbf)

    2. Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.

    3. Check whether the parking brake drags or not.

    4. When operating the parking brake lever, check that the brake warning light comes on.

      Standard
      Brake warning light always comes on at the first notch.

  6. INSTALL CONSOLE BOX SUB-ASSEMBLY REAR

    A0137IU

    1. Install the console box with the 2 bolts.

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }