STEERING ANGLE SENSOR REMOVAL

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.


  1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE STEERING PAD

    A0135YBE01

    1. Place the front wheels facing straight ahead.

    2. Using "Torx" socket wrench T30, loosen the 2 screws until the screw thread catches on the screw case.

    3. A01389P

      Pull the steering pad out of the steering wheel and support the steering pad with one hand, as shown in the illustration.

      Note

      When removing the steering pad, do not pull the airbag wire harness.

    4. Disconnect the horn connector.

    5. Disconnect the airbag connector, as shown in the illustration.

      Note

      When handling the airbag connector, do not damage the airbag wire harness.

    6. Remove the steering pad.

  4. REMOVE STEERING WHEEL ASSEMBLY

    A0138CJE01
    Text in Illustration
    *a Matchmark

    1. Remove the nut and place matchmarks on the steering wheel assembly and the steering main shaft.

    2. Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

  5. REMOVE STEERING COLUMN UPPER COVER

    A0136OJE02

    1. Remove the 2 screws while turning the steering wheel to the right and left.

    2. Disengage the 4 claws and remove the steering column cover upper.

    3. A0136TV

      Remove the steering column cover upper, as shown in the illustration (w/ tachometer).

    4. A0136HY

      If the steering column cover upper is difficult to remove, loosen the screw behind the tachometer, pull up and extend the tachometer, and then remove the steering cover upper (w/ tachometer).

  6. REMOVE STEERING COLUMN LOWER COVER

    A0136RZ

    1. Remove the screw and steering column lower cover.

  7. REMOVE SPIRAL CABLE SUB-ASSEMBLY

    A0137TJ

    1. Disconnect the horn connector.

    2. Disconnect the airbag connector, as shown in the illustration.

      Note

      When handling the airbag connector, do not damage the airbag wire harness.

    3. Disconnect the steering angle sensor connector (w/ VSC).

    4. Disengage the 3 claws and remove the spiral cable.

  8. REMOVE STEERING ANGLE SENSOR

    A01379ZE05
    Text in Illustration
    *a Pin

    1. Disengage the 6 claws and 2 pins, and remove the steering angle sensor from the spiral cable.