YAW RATE AND ACCELERATION SENSOR REMOVAL

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ front seat side airbag) Click here.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE FRONT SEAT ASSEMBLY

    A0136YG

    1. Using a clip remover, remove the wire harness clamp and connector clamp.

    2. Disconnect the buckle switch connector (w/ buckle switch connector).

    3. Disconnect the front seat side airbag connector, as shown in the illustration (w/ front seat side airbag).

    4. A0138FD

      Using a T40"TORX" socket wrench, remove the 4 bolts and front seat.

  3. REMOVE YAW RATE AND ACCELERATION SENSOR BRACKET

    A0138AE

    1. Remove the 2 bolts and yaw rate and acceleration sensor bracket.

  4. REMOVE YAW RATE AND ACCELERATION SENSOR

    A01385W

    1. Disconnect the yaw rate and acceleration sensor connector.

    2. Disengage the wire harness clamp.

    3. Remove the 2 nuts and yaw rate and acceleration sensor.