VEHICLE STABILITY CONTROL SYSTEM DTC CHECK / CLEAR


  1. DTC CHECK/CLEAR (Using an Intelligent Tester)


    1. Check the DTC.


      1. Connect the intelligent tester to the DLC3.

      2. Turn the ignition switch to ON.

      3. Turn the intelligent tester on.

      4. Read the DTCs following the prompts on the tester screen. Enter the following menus: Chassis / ABS/VSC/TRC / DTC.

      5. Check the details of the DTCs Click here.

    2. Clear the DTC.


      1. Connect the intelligent tester to the DLC3.

      2. Turn the ignition switch to ON.

      3. Turn the intelligent tester on.

      4. Operate the intelligent tester to clear the codes. Enter the following menus: Chassis / ABS/VSC/TRC / DTC / Clear.

  2. DTC CHECK/CLEAR (Using an SST Check Wire)


    1. A0136XBE86

      Check the DTC.


      1. Using SST, connect terminals TC and CG of the DLC3.

        SST
        09843-18040

      2. Turn the ignition switch to ON.

      3. Observe the blinking pattern of the ABS warning and VSC warning lights in order to identify the DTC.

        Tech Tips

        If no code appears, inspect the TC and CG terminal circuit, and ABS warning and VSC warning light circuits.

        Trouble Area See procedure
        TC and CG terminal circuit

        Click here

        ABS warning light circuit (Remains on)

        Click here

        ABS warning light circuit (Does not come on)

        Click here

        VSC warning light circuit (Remains on)

        Click here

        VSC warning light circuit (Does not come on)

        Click here

      4. As an example, the illustration below shows the blinking patterns of the normal system code and trouble codes 11 and 21 for ABS warning and VSC warning lights.

        A01367NE07

      5. The codes are explained in the code table Click here.

      6. After completing the check, disconnect terminals TC and CG of the DLC3.

        Tech Tips

        If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.

    2. Clear the DTC.


      1. A0136XBE86

        Using SST, connect terminals TC and CG of the DLC3.

        SST
        09843-18040

      2. Turn the ignition switch to ON.

      3. A01373A

        Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

      4. Check that the warning light indicates a normal system code.

      5. Remove SST from the terminals of the DLC3.

        Tech Tips

        Clearing the DTCs cannot be performed by disconnecting the battery terminal or the ECU-IG fuse.

  3. END OF DTC CHECK/CLEAR


    1. Turn the ignition switch to ON.

    2. Check that the ABS warning light goes off within approximately 3 seconds.