VEHICLE STABILITY CONTROL SYSTEM PROBLEM SYMPTOMS TABLE
Tech Tips
-
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
-
Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Note
When replacing the brake actuator assembly, sensor, etc., turn the ignition switch off.
| Symptom | Suspected Area | See page |
|---|---|---|
| ABS, BA and/or EBD does not operate | Check for DTCs again and make sure that the normal system code is output. | |
| IG power source circuit | ||
| Front speed sensor circuit | ||
| Rear speed sensor circuit | ||
| Check the brake actuator assembly with the intelligent tester. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. | ||
| If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). | ||
| ABS, BA and/or EBD does not operate efficiently | Check for DTCs again and make sure that the normal system code is output. | |
| Front speed sensor circuit | ||
| Rear speed sensor circuit | ||
| Stop light switch circuit | ||
| Check the brake actuator assembly with the intelligent tester. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. | ||
| If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). | ||
| ABS sensor DTC check cannot be done | Check for DTCs again and make sure that the normal system code is output. | |
| TC and CG terminal circuit | ||
| If the symptoms still occur even after the above circuit in suspected areas has been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). | ||
| ABS warning light abnormal (Remains on) | ABS warning light circuit | |
| Brake actuator assembly (Skid control ECU) | ||
| ABS warning light abnormal (Does not come on) | ABS warning light circuit | |
| Brake actuator assembly (Skid control ECU) | ||
| Brake warning light abnormal (Remains on) | Brake warning light circuit | |
| Brake actuator assembly (Skid control ECU) | ||
| Brake warning light abnormal (Does not come on) | Brake warning light circuit | |
| Brake actuator assembly (Skid control ECU) | ||
| VSC and/or TRC does not operate | Check for DTCs again and make sure that the normal system code is output. | |
| IG power source circuit | ||
| Check the hydraulic circuit for leaks. | - | |
| Front speed sensor circuit | ||
| Rear speed sensor circuit | ||
| Yaw rate and acceleration sensor circuit | ||
| Steering angle sensor circuit | ||
| If the symptoms still occur even after the above circuit in suspected area have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). | ||
| VSC sensor DTC check cannot be done | Check for DTCs again and make sure that the normal system code is output. | |
| TC and CG terminal circuit | ||
| If the symptoms still occur even after the above circuit in suspected area has been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). | ||
| VSC warning light abnormal (Remains on) | VSC warning light circuit | |
| Brake actuator assembly (Skid control ECU) | ||
| VSC warning light abnormal (Does not come on) | VSC warning light circuit | |
| Brake actuator assembly (Skid control ECU) | ||
| SLIP indicator light abnormal (Remains on) | SLIP indicator light circuit | |
| Brake actuator assembly (Skid control ECU) | ||
| SLIP indicator light abnormal (Does not come on) | SLIP indicator light circuit | |
| Brake actuator assembly (Skid control ECU) | ||
| Sensor check cannot be done | TS and CG terminal circuit | |
| Brake actuator assembly (Skid control ECU) |