FRONT SHOCK ABSORBER WITH COIL SPRING REASSEMBLY


  1. INSTALL FRONT COIL SPRING

    A0137OIE02
    Text in Illustration
    *a Lower End

    1. Using SST, compress the front coil spring.

      SST
      09727-30021   ( 09727-00010, 09727-00021, 09727-00031 )

      Note

      Do not use an impact wrench. It will damage SST.

    2. Install the front coil spring onto the shock absorber front.

      Note

      A spring of larger diameter should be installed in the upward direction.

      Tech Tips

      Fit the lower end of the front coil spring into the gap of the absorber lower seat.

  2. INSTALL FRONT SPRING BUMPER

  3. INSTALL FRONT COIL SPRING INSULATOR UPPER

  4. INSTALL FRONT COIL SPRING SEAT UPPER

  5. INSTALL STRUT MOUNTING BEARING

  6. INSTALL FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT


    1. Provisionally tighten the nut.

    2. A0135SHE01
      Text in Illustration
      *1 Long Socket Hexagon Wrench 6

      Using SST and a long socket hexagon wrench 6, fix the shock absorber rod and tighten the nut.

      SST
      09729-97202
      Torque:
      without SST
      33 N*m  { 340 kgf*cm, 25 ft.*lbf }
      with SST
      29 N*m  { 300 kgf*cm, 22 ft.*lbf }

      Tech Tips


      • This torque value is effective when SST is parallel to the torque wrench.

      • This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.8 in.) and SST with a fulcrum length of 40 mm (1.57 in.).

      • If using a torque wrench with a length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification Click here.

    3. Remove the SST from the front coil spring.

  7. INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY