ANTI-LOCK BRAKE SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Warm up the engine.

    2. Turn the ignition switch off.

    3. Connect the intelligent tester to the DLC3.

    4. Turn the ignition switch to ON.

    5. Turn the intelligent tester on.

    6. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

    7. According to the display on the intelligent tester, read the Data List.

      ABS/VSC/TRC
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      ABS Motor Relay ABS motor relay / OFF or ON

      OFF: Motor relay off

      ON: Motor relay on

      		 -
      Solenoid Relay ABS solenoid relay / OFF or ON

      OFF: Solenoid relay off

      ON: Solenoid relay on

      		 -
      Stop Light SW Stop light switch / OFF or ON

      OFF: Brake pedal released

      ON: Brake pedal depressed

      		 -
      Parking Brake SW Parking brake switch / OFF or ON

      OFF: Parking brake released

      ON: Parking brake applied

      		 -
      FR Wheel Speed Front wheel speed sensor RH reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
      FL Wheel Speed Front wheel speed sensor LH reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
      RR Wheel Speed Rear wheel speed sensor RH reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
      RL Wheel Speed Rear wheel speed sensor LH reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
      ECU IG Power Voltage ECU IG Power supply voltage /Normal, too High, too Low

      Normal: 9.5 to 14 V

      too High: 14 V or more

      too Low: Below 9.5 V

      		 -
      ABS Solenoid (SFRR) ABS solenoid (SFRR) / OFF or ON

      OFF: Not operating

      ON: Operating

      		 -
      ABS Solenoid (SFRH) ABS solenoid (SFRH) / OFF or ON

      OFF: Not operating

      ON: Operating

      		 -
      ABS Solenoid (SFLR) ABS solenoid (SFLR) / OFF or ON

      OFF: Not operating

      ON: Operating

      		 -
      ABS Solenoid (SFLH) ABS solenoid (SFLH) / OFF or ON

      OFF: Not operating

      ON: Operating

      		 -
      ABS Solenoid (SRRR) ABS solenoid (SRRR) / OFF or ON

      OFF: Not operating

      ON: Operating

      		 -
      ABS Solenoid (SRRH) ABS solenoid (SRRH) / OFF or ON

      OFF: Not operating

      ON: Operating

      		 -
      ABS Solenoid (SRLR) ABS solenoid (SRLR) / OFF or ON

      OFF: Not operating

      ON: Operating

      		 -
      ABS Solenoid (SRLH) ABS solenoid (SRLH) / OFF or ON

      OFF: Not operating

      ON: Operating

      		 -
      Vehicle Speed Maximum wheel speed sensor reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
      Test Mode Test mode : Normal or Test

      Normal: Normal mode

      Test: During test mode

      		 -
      Number of DTC Number of DTC recorded / Min.: 0, Max.: 255 - -

  2. ACTIVE TEST

    Tech Tips

    Using the intelligent tester to perform Active Tests allows relays, VSV, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Warm up the engine.

    2. Turn the ignition switch off.

    3. Connect the intelligent tester to the DLC3.

    4. Turn the ignition switch to ON.

    5. Turn the intelligent tester on.

    6. Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

    7. According to the display on the intelligent tester, perform the Active Test.

      ABS/VSC/TRC
      Tester Display Test Part Control Range Diagnostic Note
      ABS Solenoid (SFRR) ABS Solenoid (SFRR) Solenoid OFF / ON Operation of solenoid (clicking sound) can be heard
      ABS Solenoid (SFRH) ABS Solenoid (SFRH) Solenoid OFF / ON Operation of solenoid (clicking sound) can be heard
      ABS Solenoid (SFLR) ABS solenoid (SFLR) Solenoid OFF / ON Operation of solenoid (clicking sound) can be heard
      ABS Solenoid (SFLH) ABS solenoid (SFLH) Solenoid OFF / ON Operation of solenoid (clicking sound) can be heard
      ABS Solenoid (SRRR) ABS solenoid (SRRR) Solenoid OFF / ON Operation of solenoid (clicking sound) can be heard
      ABS Solenoid (SRRH) ABS solenoid (SRRH) Solenoid OFF / ON Operation of solenoid (clicking sound) can be heard
      ABS Solenoid (SRLR) ABS solenoid (SRLR) Solenoid OFF / ON Operation of solenoid (clicking sound) can be heard
      ABS Solenoid (SRLH) ABS solenoid (SRLH) Solenoid OFF / ON Operation of solenoid (clicking sound) can be heard
      ABS Solenoid (SFRR&SFRH) ABS solenoid (SFRR&SFRH) Solenoid OFF / ON Operation of solenoid (clicking sound) can be heard
      ABS Solenoid (SFLR&SFLH) ABS solenoid (SFLR&SFLH) Solenoid OFF / ON Operation of solenoid (clicking sound) can be heard
      ABS Solenoid (SRRR&SRRH) ABS solenoid (SRRR&SRRH) Solenoid OFF / ON Operation of solenoid (clicking sound) can be heard
      ABS Solenoid (SRLR&SRLH) ABS solenoid (SRLR&SRLH) Solenoid OFF / ON Operation of solenoid (clicking sound) can be heard
      ABS Solenoid (SFRH&SFLH) ABS solenoid (SFRH&SFLH) Solenoid OFF / ON Operation of solenoid (clicking sound) can be heard
      Solenoid Relay ABS solenoid relay Solenoid OFF / ON Operation of solenoid (clicking sound) can be heard
      ABS Motor Relay ABS motor relay Relay OFF / ON Operation sound of motor can be heard
      ABS Warning Light ABS warning light Warning light OFF / ON Observe combination meter
      Brake Warning Light Brake warning light Warning light OFF / ON Observe combination meter