ANTI-LOCK BRAKE SYSTEM DTC CHECK / CLEAR


  1. DTC CHECK (USING INTELLIGENT TESTER)


    1. Check DTCs.


      1. A0136OXE02

        Connect the intelligent tester to the DLC3.

      2. Turn the ignition switch to the ON position.

      3. Turn the tester ON.

      4. Read the DTCs using the intelligent tester.

        Select the following menu items: Chassis / ABS/VSC/TRC / DTC.

  2. DTC CLEAR (USING INTELLIGENT TESTER)


    1. Clear the DTCs.


      1. Connect the intelligent tester to the DLC3.

      2. Turn the ignition switch to the ON position.

      3. Turn the tester ON.

      4. Clear the DTCs using the intelligent tester.

        Select the following menu items: Chassis / ABS/VSC/TRC / DTC / Clear.

  3. DTC CHECK (USING SST CHECK WIRE)


    1. Check DTCs.


      1. Using SST, connect terminals TC and CG of the DLC3.

        SST
        09843-18040

      2. Turn the ignition switch to the ON postion.

      3. Read 2-digit DTCs indicated by the blinking of the ABS warning light on the combination meter.

        Tech Tips


        • If the ABS warning light does not blink, inspect the ABS warning light circuit and TC terminal circuit.

          Trouble Area See page
          ABS warning light circuit

          Click here

          TC terminal circuit

          Click here

        • As an example, the blinking patterns of the normal system code and DTCs 11 and 21 are shown below.

          A01367NE02

        • DTCs are explained in the DTC chart on page Click here.

      4. After completing the check, disconnect the SST from terminals TC and CG of the DLC3, and turn the ignition switch to OFF.

        Tech Tips

        If 2 or more malfunctions are detected at the same time, the lowest numbered DTC is displayed first.

  4. CLEAR DTC (USING SST CHECK WIRE)


    1. Clear the DTCs.


      1. A0136XBE02

        Using SST, connect terminals TC and CG of the DLC3.

        SST
        09843-18040

      2. Turn the ignition switch to the ON position.

      3. A01373A

        Clear the DTCs stored in the skid control ECU by depressing the brake pedal 8 times or more within 5 seconds.

      4. Check that the warning light blinks in the normal system code pattern.

      5. Remove the SST from the terminals of the DLC3.

      6. Turn the ignition switch to OFF.

        Tech Tips

        Clearing the DTCs cannot be performed by removing the battery cable or ECU-IG fuse.

  5. END OF DTC CHECK/CLEAR


    1. Turn the ignition switch to the ON position.

    2. Check that the ABS warning light goes off within approximately 3 seconds.

    3. Turn the ignition switch to OFF.