SELECT STROKE SENSOR REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE BATTERY


    1. Loosen the nut and disconnect the battery positive terminal.

    2. A0136EQE01

      Remove the bolt and battery clamp.

    3. Remove the battery.

  3. SEPARATE ENGINE ROOM RELAY BLOCK

    A0138XK

    1. Remove the 2 bolts.

    2. Disengage the claw and separate the engine room relay block.

    3. A0136C9

      Provisionally set the relay block to the hood support rod.

  4. REMOVE BATTERY CLAMP SUB-ASSEMBLY


    1. Disengage the 2 wire harness clamps.

    2. A0135TU

      Remove the 3 bolts and battery clamp.

  5. REMOVE SELECT STROKE SENSOR

    A01362W

    1. Disconnect the select stroke sensor connector.

    2. Remove the 2 screws and select stroke sensor from the shift and select actuator.

    3. Remove the O-ring from the select stroke sensor.