MULTI-MODE MANUAL TRANSAXLE SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. CUSTOMER PROBLEM ANALYSIS


    NEXT

  3. CONNECT INTELLIGENT TESTER TO DLC3

    Tech Tips

    If the display indicates a communication fault in the tool, inspect the DLC3.


    NEXT

  4. CHECK CAN COMMUNICATION SYSTEM


    1. Check for output DTCs.

      Tech Tips

      The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, check that there is no trouble in the CAN communication system.


      CAN SYSTEM DTC IS OUTPUT (PROCEED DTC U0100 INSPECTION PROCEDURE)

      NO CAN SYSTEM DTC (GO TO STEP 5)

  5. CHECK DTC AND FREEZE FRAME DATA

    Note

    Record or print DTCs and freeze frame data, if necessary. Refer to the relevant pages Click here.


    NEXT

  6. CLEAR DTC AND FREEZE FRAME DATA

    Tech Tips

    Refer to the relevant pages Click here.


    NEXT

  7. VISUAL INSPECTION


    NEXT

  8. PROBLEM SYMPTOM CONFIRMATION


    SYMPTOM DOES NOT OCCUR: Go to step 9

    SYMPTOM OCCURS: Go to step 10

  9. SYMPTOM SIMULATION

    Tech Tips

    Refer to the relevant pages Click here.


    NEXT

  10. DTC CHECK

    Tech Tips

    Refer to the relevant pages Click here.


    DTC OUTPUT: Go to step 11

    NO DTC OUTPUT: Go to step 12

  11. DTC CHART

    Tech Tips

    Refer to the relevant pages Click here.


    NEXT
    Go to step 13

  12. PROBLEM SYMPTOMS TABLE

    Tech Tips

    Refer to the relevant pages Click here.


    NEXT

  13. CIRCUIT INSPECTION

    Tech Tips

    Refer to the relevant pages Click here.


    NEXT

  14. IDENTIFICATION OF PROBLEM


    NEXT

  15. ADJUSTMENT, REPAIR


    NEXT

  16. CONFIRMATION TEST


    NEXT
    END