SHIFT AND SELECT LEVER SHAFT REASSEMBLY


  1. INSTALL SELECT LEVER SHAFT OIL SEAL

    A0135X1E01

    1. Using SST and a hammer, drive a new select lever shaft oil seal into the control shaft cover.

      SST
      09950-60010   ( 09951-00220 )
      09950-70010   ( 09951-07100 )
      Drive in depth
      2.0 to 2.5 mm (0.0788 to 0.0984 in.)

  2. INSTALL CONTROL SHAFT COVER OIL SEAL

    A0137IDE01

    1. Using SST and a hammer, drive a new control shaft cover oil seal into the control shaft cover.

      SST
      09950-60010   ( 09951-00280 )
      09950-70010   ( 09951-07100 )
      Drive in depth
      0 to 0.5 mm (0 to 0.0196 in.)

  3. INSTALL SHIFT AND SELECT LEVER SHAFT


    1. A0137E4

      Install the shift lever boot onto the shift and select lever shaft.

    2. Install the shift and select lever shaft with the shift lever boot onto the control shaft cover.

    3. A0135UQE02
      Text in Illustration
      *1 Rope

      Using a screwdriver and hammer, tap a new snap ring onto the shift and select lever shaft.

      Tech Tips

      Lifting the control shaft cover up with a piece of rope or equivalent makes the work easier.

  4. INSTALL INNER SELECT LEVER


    1. A0137C5

      Install the inner select lever onto the control shaft cover.

  5. INSTALL SELECT LEVER SHAFT


    1. Apply adhesive to the bolt threads.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    2. A0136IME01

      Install the select lever shaft onto the inner select lever and the control shaft cover with the bolt.

      Torque:
      38 N*m  { 387 kgf*cm, 28 ft.*lbf }

      Note

      Fit the edge of the inner select lever to the groove of the select lever shaft, as shown in the illustration.

  6. INSTALL NO. 2 SELECT SPRING SEAT


    1. A0137NK

      Install the No. 2 select spring seat onto the shift and select lever shaft.

  7. INSTALL SELECT RETURN COMPRESSION SPRING


    1. A0137I3

      Install the select return compression spring onto the shift and select lever shaft.

  8. INSTALL INNER NO. 1 SHIFT LEVER


    1. A01364R

      Install the inner No. 1 shift lever and the shift interlock plate onto the shift and select lever shaft.

    2. A013609

      While pushing up the inner No. 1 shift lever so that the hole in the inner lever aligns with the hole in the shift and select lever shaft, insert a pin punch half way into the inner lever, and using the other pin punch and a hammer, drive in the slotted spring pin. When the inner No. 1 shift lever is fixed with the slotted spring pin, pull out the pin punch while holding the inner lever.

      Drive in depth
      -0.5 to 0.5 mm (-0.020 to 0.020 in.)
    3. A0135UG

      Using a screwdriver and hammer, tap a new snap ring onto the shift and select lever shaft.