TRANSMISSION CONTROL CABLE REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

  4. REMOVE CONSOLE BOX

    A0137LL

    1. Turn the shift knob in the direction indication by the arrow in the illustration to remove it.

    2. Remove the box bottom mat.

    3. Remove the bolt <B>.

    4. Disengage the 2 claws and remove the console box.

  5. SEPARATE FLOOR SHIFT SHIFT LEVER ASSEMBLY


    1. A0137WR

      Separate the wire harness.

    2. A013739

      Remove the 4 bolts and shift lever.

  6. REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY

    A0137VP

    1. Remove the clip and separate the transmission control select cable from the floor shift shift lever.

    2. A0138OME02

      Using a screwdriver, release the claw.

    3. Separate the transmission control select cable from the shift lever retainer.

    4. A01368OE01

      Remove the clip and separate the transmission control shift cable from the floor shift shift lever.

    5. A0138OME02

      Using a screwdriver, release the claw.

    6. Separate the transmission control shift cable from the shift lever retainer.

  7. REMOVE BATTERY


    1. Loosen the nut and disconnect the battery positive (+) terminal.

    2. A0136L6

      Remove the bolt and the battery clamp.

    3. Remove the battery.

  8. SEPARATE ENGINE ROOM RELAY BLOCK

    A0138XK

    1. Remove the 2 bolts.

    2. Disengage the claw and separate the engine room relay block.

    3. A0138NO

      Disengage the 3 wire harness clamps.

    4. A0136C9

      Provisionally set the engine room relay block to the hood support rod.

  9. REMOVE BATTERY HOLD DOWN CLAMP


    1. A0135TU

      Remove the 3 bolts and the battery clamp sub-assembly.

  10. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY

    A0135UNE01

    1. Remove the clip A and clip B, then separate the transmission shift cable from the manual transaxle.

    2. A0136KNE01

      Remove the clip A and clip B, then separate the transmission select cable from the manual transaxle.

  11. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

    A0136FM

    1. Remove the 3 nuts and pull the transmission control cable out through the floor hole.