TRANSMISSION CONTROL CABLE REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

  3. REMOVE CONSOLE BOX

    A0137LLE01

    1. Remove the shift knob.

    2. Remove the box bottom mat.

    3. Remove the bolt <E>.

    4. Disengage the 2 claws and remove the console box.

  4. SEPARATE FLOOR SHIFT SHIFT LEVER ASSEMBLY


    1. A0137WR

      Separate the wire harness.

    2. A013739

      Remove the 4 bolts and shift lever.

  5. REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY

    A0137VP

    1. Remove the clip and separate the transmission control select cable from the floor shift shift lever.

    2. A0138OME02

      Using a screwdriver, release the claw.

    3. Separate the transmission control select cable from the shift lever retainer.

    4. A01368OE01

      Remove the clip and separate the transmission control shift cable from the floor shift shift lever.

    5. A0138OME02

      Using a screwdriver, release the claw.

    6. Separate the transmission control shift cable from the shift lever retainer.

  6. REMOVE BATTERY


    1. Loosen the nut and disconnect the battery positive terminal.

    2. A0136EQE01

      Remove the bolt and battery clamp.

    3. Remove the battery.

  7. SEPARATE ENGINE ROOM RELAY BLOCK

    A0138XK

    1. Remove the 2 bolts.

    2. Disengage the claw and separate the engine room relay block.

    3. A0136C9

      Provisionally set the relay block to the hood support rod.

  8. REMOVE BATTERY HOLD DOWN CLAMP


    1. Disengage the 2 wire harness clamps.

    2. A0135TU

      Remove the 3 bolts and battery clamp.

  9. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY

    A0135UNE01

    1. Remove the clip A and clip B, then separate the transmission shift cable from the manual transaxle.

    2. A0136KNE01

      Remove the clip A and clip B, then separate the transmission select cable from the manual transaxle.

  10. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

    A0136FM

    1. Remove the 3 nuts and pull the transmission control cable out through the floor hole.