CLUTCH STROKE SENSOR (for C551A) REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE BATTERY


    1. Loosen the nut and disconnect the battery positive (+) terminal.

    2. A0136L6

      Remove the bolt and the battery clamp.

    3. Remove the battery.

  4. SEPARATE ENGINE ROOM RELAY BLOCK

    A0138XK

    1. Remove the 2 bolts.

    2. Disengage the claw and separate the engine room relay block.

    3. A0138NO

      Disengage the 3 wire harness clamps.

    4. A0136C9

      Provisionally set the engine room relay block to the hood support rod.

  5. REMOVE BATTERY CLAMP SUB-ASSEMBLY


    1. A0135TU

      Remove the 3 bolts and the battery clamp sub-assembly.

  6. REMOVE CLUTCH STROKE SENSOR

    A01388T

    1. Separate the connector from the clamp bracket.

    2. A0137B3

      Disconnect the clutch stroke sensor connector.

    3. Remove the 2 screws and stroke sensor from the clutch actuator.

    4. Remove the O-ring.