LUBRICATION SYSTEM ON-VEHICLE INSPECTION


  1. CHECK ENGINE OIL LEVEL


    1. Warm up the engine, stop the engine and wait 5 minutes. The oil level should be between the dipstick's low level mark and full level mark.

      If low, check for leakage and add oil up to the full level mark.

      Note

      Do not fill with engine oil above the full level mark.

  2. CHECK ENGINE OIL QUALITY


    1. Check the oil for deterioration, water contamination, discoloring or thinning.

      If the quality is visibly poor, replace the oil.

      Oil grade
      API grade SL, Energy-Conserving or ILSAC multigrade engine oil is recommended. SAE 5W-30 is the best choice for your vehicle for good fuel economy and good starting in cold weather.

  3. REMOVE ENGINE OIL PRESSUR SWITCH ASSEMBLY


    1. A0138KG

      Disconnect the engine oil pressure switch connector.

    2. Using a 24 mm deep socket wrench, remove the engine oil pressure switch.

  4. INSTALL OIL PRESSURE GAUGE


    1. A0136UC

      Install the oil pressure gauge with the adapter.

  5. WARM UP ENGINE

  6. CHECK OIL PRESSURE

    Specification
    Engine rpm Oil pressure
    750 rpm

    30 kPa (0.3 kgf/cm2, 4.3 psi) or more
    3,000 rpm

    200 kpa (2.0 kgf/cm2, 28.4 psi) or more

    If the oil pressure is not as specified, repair the lubrication system.

  7. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. A0137AQE01

      Remove the oil pressure gauge.

    2. Apply adhesive to 2 or 3 threads of the oil pressure switch.

      Adhesive
      Part No.08833-00080, TREE BOND 1334, LOCTITE 242 or equivalent
    3. A0138KG

      Using a 24 mm deep socket wrench, install the oil pressure switch.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine within 1 hour after installation.

    4. Connect the engine oil pressure switch connector.