EXHAUST PIPE INSTALLATION


  1. INSTALL EXHAUST TAIL PIPE ASSEMBLY


    1. Install the 2 exhaust pipe No.4 supports and the exhaust tail pipe assembly.

      A0138JX

  2. INSTALL EXHAUST FRONT PIPE ASSEMBLY


    1. A0137UN

      Using vernier calipers, measure the free length of the compression spring.

      Minimum length
      40.5 mm (1.594 in.)

      • If the length is not as specified, replace the compression spring.

    2. A0138PGE01

      Using a plastic hammer and a wooden block, tap in a new exhaust pipe gasket until its surface is flush with the exhaust manifold.

      Note


      • Be sure to install the exhaust pipe gasket in the correct direction.

      • Do not damage the outer surface of the exhaust pipe gasket.

      • Do not reuse the exhaust pipe gasket.

      • Do not push in the gasket with the exhaust pipe when connecting it.

    3. Install the exhaust front pipe assembly and a new exhaust pipe gasket with the 2 compression springs and 2 bolts.

      Torque:
      45 N*m  { 459 kgf*cm, 33 ft.*lbf }

    4. Install the exhaust pipe No.4 support.

    5. Install the bolt and clamp.

      Torque:
      32 N*m  { 326 kgf*cm, 24 ft.*lbf }
      A0135VGE04

      Note


      • Clamp marks and stamping should be aligned.

  3. INSTALL OXYGEN SENSOR


    1. A0137BW

      Using SST, install the oxygen sensor.

      SST
      09224-00010
      Torque:
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

    2. Connect the oxygen sensor connector.

  4. INSPECT FOR EXHAUST GAS LEAKS